I am new with WD Blue rings II (2x500 GB). Originally it was on firmware 184.108.40.206. I have enabled ssh, than I tried enable spindown.. but no much success with it. I tried as well to use ramdisc etc.
finally I started the instalation of Lenny's FW. Everyting was OK. But when I installed SAMBA I have very ugly speeds (tried samba 2 and samba 3 too). Reading is somewhere between 2 - 3 MB, writing 0.8 - 1.2 MB
FTP reading about 0.8 MB as well
This is worst than with original FW…
Is there any possiblity to return to factory defaults?