Bought second hand an MBWE 2, but bricked it quite fast.
Used this guide to unbrick it:
This goes perfectly up to the points 11 and 12: Insert 2nd disk an start up MBWE.
Then it starts up briefly, but within a few minutes, it powers off again.
When I extract the disk and read it with an external SATA-USB device, I see that the disk is not formatted yet.
Did this twice in 2 directions:
- ran the mbwe-install.sh script on drive A, inserted it in the MBWE, cleaned drive B and installed it: no success
- ran the mbwe-install.sh script on drive B, inserted it in the MBWE, cleaned drive A and installed it: no success
In both cases the installed drives comes up with status good in the network manager, but as soon as second drive is inserted, it powers off again.